COMPEX MMJ5N26dBm Wireless-N outdoorAP 802.11an MIMO JUNIOR 5GHz

Skladové číslo: 910487056

1 646,40 Kč
(Cena bez DPH)

1 976,- Kč
(Cena s DPH)

MIMO Junior5 (MMJ5) 2T2R is a high-performance Indoor/Outdoor Access Point with integrated PoE. Using Atheros AR7130(300MHz) Processor, MIMO Junior is able to support high-speed data transmission of up to 54Mbps, 108 Mbps or 300Mbps.

MIMO Junior5 is embedded with an integrated directional dualpolarization (vertical and horizontal) antenna, supporting 5GHz (17dBi), 2*rSMA connectors fro external antenna are optional

Dual-polarization antenna provides good diversity coverage and better noise immunity. It has integrated high power radio, coupled with firmware which support multiple SSID, long range support to allow for higher throughput, wider coverage. The device is a powerful and yet easy to use and implement for wireless ISP


Please read this test report about 3,2km PtP link with 109Mbps performance !! Complete with configuration description,signal parameters, troughput and latency. Compared with NS M5 results - COMPEX MIMO series product can achieve 10% better troughput !!. Superchannel feature support (4,9-6,1GHz and scalable channel width - 5/10/20/40MHz). Usefull can be for tag vlan operators this new VLAN support feature.

Features

Atheros eXtended Range technology
300Mhz, 32MB SDRAM, 4MB Flash
All compex WLM Series MiniPCI Supported (WLM200N5-26dBm (2T2R) inside)
Built in dual-polarization antenna, 17dBi for 802.11an band
Support Power-over-Ethernet(PoE passive)
Supports 64/128-bit WEP, TKIP, AES, IEEE802.1x authentication
Embedded NAND flash
Antenna Alignment
Build in with Grounding Terminal
Weatherproof casing IP55


available NOW!!!

Complete datasheet here.

11n standard uses OFDM modulation and is therefore perfectly legal to operate these facilities under the general authority as 11a/b/g.

The speed at which the devices communicate determine the so-called modulation schemes and code MSC. These are defined total 31st MSC 0-7 uses one antenna to transmit and receive (so-called single stream) It is possible to have a standard width of 20 MHz channel, but for higher speed is selected to be 40 MHz. MSC7 theoretical maximum speed of 150 Mbps and is used only one antenna. Real rates are above 70 Mbps, but we'll see how it will be in our other tests.

MSC 8-15 adds MIMO (Multile Input Multiple Output), it is the use of multiple antennas on both sides. These schemes specifically 2 antennas (known as MIMO 2x2). Not so that one antenna transmits and one receives, but always send and receive both antennas. Is used here to increase the speed of phase shifts (very simply say). These schemes used innovations products such as MIMO Junior, MIMO Station, Wodasign 11N router and a theoretical maximum speed is 300 Mbps. The measurements we showed that it is preferable to using separate antennas use different pairs of polarization antennas. The new MIMO antenna BOX, DUPLEX JIROSU or AirMAX from UBNT already own 2 antennas have, so just connect using the equipment. Indicates the maximum real rate of about 150 Mbps. We measured a short distance where the max speed of just under 100 Mbps. Detailed we measured the links at around 200 to 600 meters and the speed is always around 75 Mbps full duplex. Detailed measurements on links 2 to 4 km you can see bellow.


Features
*-Atheros eXtended Range technology
*-300Mhz, 16MB SDRAM, 4MB Flash
*-1x Compex WLM200N5-23 ESD 23dbm MiniPCI card pre-installed
*-Built-in internal high sensitivity dual-polarization antenna , 8dbi for 2.4GHz band or 17dBi for 5GHz band
*- Spare external antennae connector
*-Support Power-over-Ethernet (PoE passive)
*-Supports 64/128-bit WPA, WEP, TKIP, AES, IEEE802.1x authentication
*-Embedded NOR flash, and support NAND flash memory expansion
*-Antenna Alignment
*-Build in with Grounding Terminal
*-Surge arrestor support
*-Weatherproof casing

Multiple SSID
 Supports up to 4 virtual access points (VAP) per radio (concurrent dual band possible), with unique BSSIDs. Traffic from each VAP can be tagged to a unique VLAN and /or bridged if required. Each VAP will be able to configure their own security (WPA, WEP, TKIP, and AES).

Long Range Support
 Suitable for long-range wireless deployment with Proprietary Long Distance Algorithm for ACK and CTS timeout adjustment support.
 Provides recommended values for the parameters and at the same time allow for manual fine-tuning for optimal performance.

Antenna Alignment
 Antenna Alignment feature allows the system integrator to align the antenna for best signal strength.


FIRMWARE INFORMATION
Operating Modes
 Access Points
 Client
 RootAP / Transparent Client (Work in Progress, FW upgrades)
 Repeater (Work in Progress, FW upgrades)
 Wireless Adapter (Work in Progress, FW upgrades)
 Wireless Routing Client (Work in Progress, FW upgrades)
 Gateway
WAN Type
 Static IP
 Dynamic IP
 PPPoE
 PPTP
 L2TP
Device Management
 HTTP / HTTPs Web Server
 SNMP V2c
 Telnet / Secure Shell (SSH)
Data Capture & Notification
 Event Login (Syslog)
 Detailed Statistics per Client
Virtual Access Point (VAP)
 Up to 4 SSIDs with unique MAC Addresses (BSSID)
 802.1q VLAN tag per VAP with Bridging
 Configurable Security (WPA, WEP, TKIP, AES, MAC Filtering) per VAP
Advanced Features
 Built-in DHCP server
 Transmission Power Control (One dB per step)(Work in Progress)
 Closed System (Suppress SSID)
 Transmission Rate Control
 Spanning Tree Protocol
Suitable for Long Range wireless deployment with high receiver
sensitivity.
Ideal as CPE device connecting PtP with a central AP
Device power from PoE through ethernet cable provide flexible installation.
IEEE 802.11h (DFS & TPC)
Enables worldwide operation through support for standards-based
Dynamic Frequency Selection (DFS) and Transmission Power Control (TPC)
SNMP Traps enable an agent to notify the management station of significant events by way of an unsolicited event.
Antenna Alignment Allows user to adjust their external antenna to receive the optimum throughput.
DHCP Relay (Only in Gateway or Wireless Routing Client Mode) Allows DHCP Clients on different subnets to get IP address from central DHCP server.
Remote Upgrade of Firmware Allows user to upgrade their firmware through Telnet/SSH
Parallel Bandwidth l(Only in Routing Mode) Provide scalable Internet bandwidth with Load Balancing and Fail-Over Redundancy.
RIP 1 / 2 (Only in Gateway or Wireless Routing Client Mode) Routing Information Protocol Version 1 / 2

1 646,40 Kč
(Cena bez DPH)

1 976,- Kč
(Cena s DPH)

 

---